, ,

Happily Ever After – How to Sew a Nursing Bra

Happily Ever After – How to Sew a Nursing Bra

In this post, I will go through how to sew a nursing bra the construction steps on . In my last post, I showed you how to draft a pattern with the same look as a vintage nursing bra, on that I thought would have great potential as a modern adaptation. Well you should see it now – it is truly a bra with a happily ever after ending!  I had a few revelations along the way, and actually thought of ways to streamline the production and make it look better, so I will share those with you as well.

The first thing to sew is the outer cup, shown in pink here. You may recall I re-cut the inner sling  (shown in white) to be one-piece with a curve on the inside edge. It was at this stage that I realised I wasn’t going to like the look of a seam along the neckline edge, even if it did save on fabric.

how to sew a nursing bra cut out

Once the outer layer cup seams are sewn, trim the two edges with some pretty trim.  We used white loop-a-licious, not because we didn’t have pink but because of the white clips, I wanted to bring more white into this bra. I show the clips sewn on here, however in reality, it is better to sew them on later in the process. Lesson #1.

how to sew a nursing bra cups

Once the outer layer cup is sewn and trimmed, our next step is to sew the frame and put the outer layers cups in the frame. Yes, indeed, we sew the outer layer cups in the frame before the inside layer. The best way to make sure they are in the right place is the  mark and match the bottom notches.

how to sew a nursing bra cup and frame

how to sew a nursing bra outer cups sewn in

The Inside Cup Layer

Now we prepare the inside layer of the nursing bra, which is the layer that attached to the strap. Serge around the inside curve. This particular fabric is Duoplex, however if I were doing this again, I would use power net, which has a bit of stretch. It’s also a bit more “meshy” like the original. Lesson #2. You can see now why we sew the inner cup layer on after the outer cup layer. They are in their correct order when you look at the cup from the right side.

how to sew a nursing bra with inside cup sewn in

Here’s a sneak peek at the  business end of the nursing bra strap tab. Is it making sense now?how to sew a nursing bra lookin good

To complete our nursing bra, we sewed the elastics to the bottom and top band, plus along the neckline edge. I don’t need to show you that, do I? Once you sew on both edges on each side of the strap tab, then you can put the other part of the nursing clip on.  Here’s a close-up of the parts of the One-handed Nursing bra clip and what parts of the bra they attach to.

Nursing-Bra-clip-labelled

Are you ready to see the finished bra? Here’s the front. You can see the outer cup dips down a little at the centre front exposing the inner cup layer.

how to sew a nursing bra feature

Here’s a view from the side. If I did this again, I wouldn’t have it dip down so much at the side. I would keep the dips confined to the upper cup. Why? So that the breast wouldn’t be inclined to pop out at the side. Lesson #3.  Check out the straps, too. They are a simple tube of fabric with the trim sewn in the seam, which helps to unify the whole design.

how to sew a nursing bra side

I hope you have enjoyed how to sew a nursing bra as well as the drafting. I certainly learned from this bra and the Happily Ever After version of the original!

Your Fairy Bra Mother,

Beverly

4 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *